Port Forwarding Setup

Report issues or bugs in RVGL or ask for help regarding any Re-Volt topic.
Teach
Posts: 2

Port Forwarding Setup

Unread post by Teach » Fri May 01, 2020 4:03 am

Image
https://imgur.com/g57Aici

This is my router settings, and I don't really know what to put and where else to put. I have tried but to no avail, now I'm asking for your help.

Help <3
Stingox
Posts: 27

Re: Port Forwarding Setup

Unread post by Stingox » Fri May 01, 2020 10:04 am

If you're only using RVGL, then do as follows:

User-defined Service Name: rvgl (or whatever)

Protocol: UDP

WAN Port: 2310

LAN Open Port you can leave empty

LAN IP Address, write your IPv4 address. You can find your IPv4 it by opening cmd.exe and typing: ipconfig /all
Your IPv4 address will be there.

Good luck !
Teach
Posts: 2

Re: Port Forwarding Setup

Unread post by Teach » Fri May 01, 2020 11:52 pm

Stingox wrote: Fri May 01, 2020 10:04 am If you're only using RVGL, then do as follows:

User-defined Service Name: rvgl (or whatever)

Protocol: UDP

WAN Port: 2310

LAN Open Port you can leave empty

LAN IP Address, write your IPv4 address. You can find your IPv4 it by opening cmd.exe and typing: ipconfig /all
Your IPv4 address will be there.

Good luck !
Same goes to TCP?
User avatar
revolting1
Posts: 60

Re: Port Forwarding Setup

Unread post by revolting1 » Sat May 02, 2020 7:58 am

The TCP protocol should not really be needed, I believe it was for speaking in servers like game ranger or others mostly discontinued because of other limitations
Post Reply